Stiffener > Section Table
Overview of Functions
This function is to set the height and thickness of the flat type longitudinal stiffener to complete the array.
Details of Functions
Edit Tab
On / Off Option
This option lets you choose whether to collectively or individually set the settings for cross-sectional changes of arranged longitudinal stiffeners.
When enabled, sets the stiffener individually.
When disabled, set to stiffener group batch.
Select stiffener
Select the flat type longitudinal stiffener complete with the array to set the section table.
Selection condition: Only stiffeners that satisfy all three conditions, longitudinal stiffener, array completion, and flat type can be selected.
Tapered section type
Set how to connect each change cross section.
Tapered : Create a stiffener by following each section with its cross section. In other words, the sections are connected.
Compartmental : Create a stiffener by separating each section.
Tapered section table (batch)
Apply section settings in a batch. Set the position, height and thickness of each section to table.
Location type : Choose whether to position each section by length or ratio.
Location : Enter a location for each section from the stiffener point.
Height, Thickness : Enter the height and thickness of each section.
Tapered section table (separate)
Apply Section settings individually. Set the position, height and thickness of each section to table.
Stiffener list : Select the number of the longitudinal stiffener you want to set the Section. Each stiffener in the group can be set.
Actual length : It shows the actual length of that stiffener. Input is not possible.
Location type : Choose whether to position each section by length or ratio.
Location : Enter a location for each section from the stiffener point.
Height, Thickness : Enter the height and thickness of each section.